LabelCombi 100 label dispenser

Name: 라벨콤비 라벨콤비100
Brand: 라벨콤비

라벨콤비 라벨콤비100

A label dispenser that, with a roll of labels loaded, peels labels one at a time from the liner and feeds them forward at 80 mm/s. It takes rolls 5-100 mm wide and up to 250 mm in outer diameter regardless of material, and shows the number of labels dispensed on an LED counter.

Label width

5-100 mm

Label material

Any material

Max label roll diameter

250 mm

Power and consumption

AC 220 V / 3 W

라벨콤비100 specifications

Use

Automatic separation of roll labels (label dispenser)

Label width

5-100 mm

Label material

Any material

Max label roll diameter

250 mm

Dispensing speed

80 mm/s (speed adjustable)

Motor speed adjustment

Levels 1-10 (normally set to 10)

Display

Counter LED (red, number of labels dispensed), dispensing length LED (green)

Power and consumption

AC 220 V / 3 W

Dimensions

136 x 174 x 280 mm (W x H x D)

Label roll specifications it accepts

The LabelCombi 100 uses labels 5-100 mm wide and takes rolls up to 250 mm in outer diameter. There is no restriction on the label material that can be used.

The unit measures 136 x 174 x 280 mm (W x H x D) and uses 3 W on AC 220 V power.

Motor speed levels 1-10 and dispensing length

Dispensing speed is 80 mm/s, and motor speed is adjusted from 1 to 10 with the UP and DOWN buttons. It is normally set to 10, the fastest.

Pressing only one of the UP or DOWN buttons lights the green dispensing length LED and shows the dispensing length setting as a number. Increasing or decreasing this number changes the length at which each label comes forward and stops.

Counter display and clearing a stop

Normally the red counter LED shows the number of labels dispensed, and pressing the counter reset button returns it to 0.

If no label is detected from the loaded roll for a while, the motor stops and the number display blinks. This state is also cleared with one press of the counter reset button.

FAQ

How do I check the current motor speed level?

Press the UP and DOWN buttons together for about 5 seconds, and the red and green LEDs blink alternately; the number shown then (1-10) is the current motor speed. In this state, change the level with UP and DOWN.

Can it take labels wider than 100 mm?

No. The LabelCombi 100 takes labels 5-100 mm wide, and rolls only up to 250 mm in outer diameter.